Installation and connection
en
15
6.
Press down on the 4 cover caps.
4.5 Tools for assembly
You require the following tools for the
assembly:
¡
Spirit level
¡
Wrench, WAF 13
¡
Wrench, WAF 17
¡
Forstner 35 mm drill bit
¡
2 mm twist drill
¡
Screwdriver
4.6 Installing the appliance
Preparing the appliance
1.
To make it easier to slide in the
appliance, turn in the appliance's
rear feet until the appliance is on
the runners.
2.
Measure the built-in niche.
3.
Lay the power cord as well as the
water inlet and water drain hose.
4.
Slide the appliance in and, at the
same time, pull through the power
cord, water inlet and water drain
hose.
5.
Connect the water inlet hose.
→
6.
Connect the water drain hose.
→