09
Fr
an
çais
Español
Deutsch
English
d.
In order to get the bottom cam
onto the mast you will need to apply
the boom first. Set the boom to the
recommended setting printed on
the bottom of the sail. Next, clamp
the boom on the mast and apply
a little bit of out-haul tension.
Note: If you have problems applying the
cams to the mast, first apply the boom
and put some out-haul tension on the sail.
Follow the same procedure outlined above.
With slightly positive outhaul it will be even
more straightforward to apply the cams.
e.
Before applying the last cam make
sure the zipper (at the bottom cam)
is open.
f.
Put one hand on the sail body just on the edge
of the mast sleeve, while your other hand goes
under the cam supporting the cam with whole
palm of your hand. Push down gently with the hand
on the edge of the sleeve while the hand under the
cam pushes the cam forward a little and it will go
on easily. Close the zipper.
4. Finish Rigging
a.
Apply down-haul and out-haul to your
preferred setting.
b.
Loop the tack strap around the base
and apply tension.
Summary of Contents for RS6
