nozzle can change shape of the nozzle jet. In the condition of using single spray
superfine atomizing nozzle will cause the pressure exceeds the water pump
setting pressure, as a result, the water pump pressure switch continuous
beating.
Personal Protective Equipment
• Ensure personal protective equipment is used. i.e gloves, goggles, coverall
and breathing mask.
Use Spot Spray Gun
• Turn the remote switch to the ON (I) position.
• To spray squeeze the gun trigger.
• Twist the spray nozzle to change from a straight stream to a cone spray pattern.
Check with the type of agent which is best to use.
USE Broadcast Lance
Fix the broadcast lance on the ATV .
• Move the broadcast lance into the broadcast position.
Broadcast Nozzle
• If needed, rotate the broadcast nozzle so that the spray pattern is pointed down
and evenly distributed.
• Ensure gloves are worn when adjusting the lance and nozzle, as dripping may
occur.
Start Spraying
• Turn the remote switch to ON (I).
• To ensure a uniform spray pattern, overlap each spray 300mm .
• See the speed/application tables to determine the speed for the ATV.
NOTE! It is possible to use the broadcast lance and spot spray gun
simultaneously.
Leaving Unattended
• If the sprayer must be left unattended;
A) disconnect the power. B) relieve the system pressure by pressing the gun
trigger. C) turn off
the vehicle and chock the wheels.
• Sprayer Becomes Inoperable
• If the sprayer becomes clogged or stops working do not attempt to repair whist
