body.
2. Before connecting any pneumatic equipment to the compressed air supply, all
mounted fittings,piping assemblies and electrical connections should be checked
for security.All plastic plugs in the equipment used for protection during shipping
should be removed.
3. No piping alterations, removal of fittings, repairing of equipment etc.Should be
attempted with air supplies connected.Air and electrical supplies must be
disconnected before beginning any adjustment, maintenance or dismantling of
equipment.
4. The maximum allowable operating pressures, temperature, flows etc. must be
strictly observed.Failure to do so might result in catastrophic failure of
equipment,and result in serious personal injury and i or death.Refer to individual
catalogues for this information,and any other operating or application limitations.
COMPRESSED AIR SAFETYFOR PNEUMATIC EQUIPMENT
WARNING:
1. Compatibility of pneumatic equipment
Ensuring the compatibility of the procured FRL equipment is the responsibility of
the person who designs the Pneumatic system and/ or System specifications.
This should be based on specifications or after analysis and / or tests to meet
specific requirements.
2. Repair & Maintenance
Assembly, handling, or repair of pneumatic systems should be performed by only
trained and experienced operators.
3. Safety First
Do not service machinery / equipment or attempt to remove any component until
safety is confirmed.
Inspection and maintenance of machinery / equipment should only be performed
after confirmation that both compressed air and electrical supply have been
positively disconnected and all residual compressed air in the system has been
completely exhausted to the atmosphere.
4. Contact the manufacturer if equipment is to be used in any of the following
conditions:
A. Equipment is to be used in conditions beyond the given specifications, or if
equipment is to be used outdoors.
