7
MAINTENANCE
WARNING!
To prevent serious injury :
Detach air supply from this product before performing any inspection,
maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise, vibration, or leaking air
occurs, have the problem corrected before further use.
CLEANING, MAINTENANCE, AND LUBRICATION
NOTICE:
These procedures are in addition to the regular checks and
maintenance explained as part of the regular operation of the Hose
Reel.
1.
BEFORE EACH USE
, inspect the general condition of the tool. Check
for:
•
loose hardware or housing,
•
misalignment or binding of moving parts,
•
cracked or broken parts, and
•
any other condition that may affect its safe operation.
2.
AFTER EACH USE
, re-wind the hose onto the reel and wipe the Hose
Reel clean with a dry cloth.
WARNING
•
Internal spring is not user serviceable or user-replaceable.
HOSE REPLACEMENT
1. Remove the Hose Stopper from the hose and set aside.
2. Pull out the old Hose and securely lock the Hose Reel.
3. Disconnect the old hose from the swivel joint and remove the hose.
4. Run the new hose through the Guide Roller and through the opening
in the drum flange.
5. Use thread seal tape on the hose fitting threads and screw the fitting
onto the swivel and tighten.
6. Attach the Hose Stopper on the end of the Hose near the Outlet
fitting.
7. Carefully release the Drum Latch and allow the Hose to wind onto the
reel, evenly distributing the Hose across the Reel.
