8
Fan Direction
16. To change the direction of the fan from
horizontal to vertical, loosen the Lock Ring
and turn the Nozzle 90°.
17. After the adjustment, tighten the Lock Ring
by hand.
Spraying Technique
IMPORTANT: Proper spraying technique is ESSENTIAL to achieve good results.
1. First, clean and prepare the Spray Gun according to the instructions under
Before First Use on page 5 and Spray Gun Setup Adjustment on page 6.
2. Keep the Spray Gun upright and at a right angle to the workpiece
–
See Figure M and Figure N.
3. Using two hands, one to steady the Cup and the other to operate the Spray Gun,
aim Nozzle at the workpiece.
CAUTION:
DO NOT STOP WHEN SPRAYING.
Spraying materials will start to set and dry
as soon as they come in contact with the air. They will cause a permanent clog if not cleared
immediately. If discontinuing spraying for more than half an hour, turn off the air supply,
disconnect Cup from Gun Body and thoroughly rinse Cup and Gun Body with fresh, clean
water.
4. Pull Trigger slowly and move Spray Gun in parallel strokes to the workpiece. Keep the
distance from the workpiece at about 6
” to 9” , depending on the flow adjustment and the
paint.
5. To avoid paint build up, start moving the Spray Gun before squeezing the Trigger.
