ELECTRICAL INFORMATION
Warning
Mains plug replacement (UK & Ireland only)
If you need to replace the fitted plug of the tool, then follow the instructions below.
Machines that are connected direct to mains supply.
For machines that are double insulated, do not require a connection to earth.
If in doubt consult a qualified electrician
The wires are coloured as follows
Blue
Neutral (N)
Brown
Live (L)
3amp BS 1363A Fuse
Always secure the wires in the plug terminals carefully make sure no loose strands
are left exposed as they can short circuit and cause injury, fire and or damaged the
tool.
Secure the cable in the cord grip firmly.
Never use a light socket. Never connect the live (L) or neutral (N) wires to the earth
pin marked (E)
NOTE: If your mains wires differ from the above consult a qualified electrician.
Always make sure the mains supply is of correct voltage and you use the correct
fuse protection
Regularly inspect all machines electrical connection and wiring condition for
damage. Any faults detected should be immediately rectified before further use of
the machine. Always have the wiring checked by a qualified electrician
In use ensure all wiring and extension cords are kept clear of any cutting tools,
sharp objects and any other workshop hazards such as wet floors, chemicals,
solvents etc.
This machine is protected by a 3 amp fuse make sure the correct fuse is used
To prevent fire or shock hazards do not expose these products to rain or moisture.
