5
OPERATION INSTRUCTIONS:
Setting Up:
Massage Operation:
Step 1: Turn on the massager
Remove all packing material from the massager, and make sure there is no
packaging underneath or around the massager. Check if there are any parts
damaged or missing during transportation.
Unwind and plug the power cord into the DC power jack on the back of the
massager.
Connect the power adapter to the socket, then the massager will beep once
and be ready to work.
Place the massager on a flat floor in front of your chair or seat.
Now your Shiatsu foot massager is ready for use.
Press the button on the remote control or the control panel. The massager
will beep and start a 15-minute massage session. In this session, the massag-
er will start at a slow speed and the low air compression intensity with heat.
Note: The heating function
The heating function will automatically activate when the massager starts
up. To cancel the heating, press the button. The red indicator light will be
turned off.
Step 2: Adjust the massage speed mode
The massager starts work at a Slow Speed Mode by default with the left
indicator light on.
Press the to swtich between the Slow Speed and Fast Speed Modes.
1.
2.
3.
4.