5
Installation:
The Messager USBi should be installed using the following steps:
Step 1:
Wall or shelf mount the unit. Screws and rubber feet are supplied in the accessory kit.
Step 2:
If connecting to an amplifier make sure it is turned OFF for this part of the installation.
Step 3:
Connect a RCA cable (supplied in the accessory kit) to the OUTPUT jack on the rear of the unit. Depending
upon the required impedance use either the 8Ω or 600Ω output RCA jack. Connect the other side to the MOH port
on the phone system, PA system or speaker.
Step 4:
If unit is already preloaded then skip to Step 5. Insert USB media. If insertion of drive is difficult, turn
the drive over and try reinserting. Drive should slide into jack smoothly.
See Message Programming & Operation
section for correct loading of your audio!
Step 5:
Attach the included power pack to a wall or power strip receptacle, then attach the other end to the jack on
the rear of the unit labeled 12VDC.
Step 6:
If any amplifiers were turned OFF during installation then turn them back ON now.
Step 7:
Adjust the volume level pot labeled VOLUME on the rear of the unit. Depending upon the application
either call into the phone system and be placed on hold OR listen to the PA systems speakers to fine tune volume.
Volume up is clockwise, volume down is counter-clockwise.
VOLUME
MADE IN USA
12VDC
500mA
OUTPUT
8Ω
600Ω
OR
To MOH port
or PA System
Wiring Diagram
