Tel-A-Greeter 204
14
Rev. 04/19/2000
After finishing a valid command, a single-
beep “success” tone plays, indicating the
command or recording was accepted. If an invalid command or value is entered, a
double-
beep “error” tone plays.
Available commands
The following are all the possible commands.
Delete message
Allows the user to erase a message from memory. While the message
is deleted the system busy signal is heard.
Syntax:
* 7 0 # 0 1 #
Delete message number 1
* 7 0 # 0 2 #
Delete message number 2
* 7 0 # 0 3 #
Delete message number 3
* 7 0 # 0 4 #
Delete message number 4
Record message
Allows the user to record messages.
If the message already exists,
you must first delete it before recording (see delete message
command above).
After the command is entered, the TAG plays a
steady series of short beeps, indicating it is ready to record. To begin
recording, dial
*
, to stop recording, dial
#
. If the maximum record time for
the message is reached (2 minutes), recording stops automatically. The
double beep error tone sounds if the selected message has not been
deleted first.
Syntax:
* 5 0 # 0 1 #
Record message number 1
* 5 0 # 0 2 #
Record message number 2
* 5 0 # 0 3 #
Record message number 3
* 5 0 # 0 4 #
Record message number 4
