Service Manual
Administrative Functions
Oxinet III
37
Maintenance (F11)
Note:
The Oxinet III software performs database maintenance automatically. The
software temporarily closes the program, performs database file maintenance, and
relaunches the program at 10:05 am every day. This maintenance procedure
normally takes less than 45 seconds to run.
During this brief period, the system
does not process any incoming data, including alarms.
To manually initiate the
database maintenance process, perform the following procedure.
To Manually Initiate Database Maintenance
Use the
F11
function to
manually initiate database maintenance
. This function is
password-protected.
1
Press the
F11
key on the keyboard.
The uShield dialog box appears (Figure 6).
2
Type the Administrative function password,
1234
, then press or click the
Ok
button.
When maintenance begins, the
Please wait..Maintenance is running. This
should take up to 5 minutes to complete
message appears (Figure 31). When
maintenance is complete, the system returns you to the
Monitor
screen.
Figure 31: Database Maintenance
Summary of Contents for Oxinet III
