Congratulations on your purchase of the Reliance Controls Easy/Tran TF furnace transfer switch. Reliance has
been manufacturing transfer switches and equipment in Racine, Wisconsin since 1982 and has been producing
high-quality electrical equipment for nearly 100 years. Reliance is the Loadside® transfer switch used in nearly
90% of the installations done by professional electricians. Your transfer switch is UL 1008 listed, for the U.S. and
Canada, and meets all requirements of the National Electrical Code.
STANDBY POWER FURNACE SWITCH
Easy/Tran
®
TF151, TF151W, TF201 and TF201W
TOOLS NEEDED FOR INSTALLATION
1. Power Drill
6. Tape Measure
2. Wire Stripper and Cutter (10 to 14 gauge)
7. Three Wall Anchors
3. Insulated Screwdrivers
8. Battery Powered Lighting during Installation
(#2 Phillips, ¼” Flat Tip or #2 Square Tip 9. A Non-Contact Voltage Detector (optional)
depending on your load center)
4. Hammer
5. Marking Pencil
PARTS LIST for
Easy / Tran
TF
FURNACE TRANSFER SWITCH
15 Amp (TF151) or 20 Amp (TF201) Single-Circuit Transfer Switch
4 Yellow Wire Connectors
SAFETY SYMBOLS USED IN THIS MANUAL
Danger indicates an imminently hazardous
situation that, if not avoided, could result in
death or serious injury.
Warning indicates a potentially hazardous
situation that, if not avoided, could result in
death or serious injury.
Caution indicates a potentially hazardous
situation that, if not avoided, may result in
minor or moderate injury.
Improper installation of the transfer
switch could cause damage or personal injury by
electrocution or fire. Installation must be performed
by a qualified electrician, or others knowledgeable of
electrical systems, in compliance with all applicable
electrical
codes.
Reliance transfer switches covered in
this manual should not be used for electric water
heaters, clothes dryers, electric ranges, central air
conditioners or other appliances or systems that may
exceed the capacity of the product.
Transfer switches are required for use with portable
generators by Article 702 of the National Electrical Code
Reliance Controls Corporation is
not responsible for damage or
injury caused by incorrect
installation of this transfer switch.
Member of the National Electrical Manufacturers Association
