Nemalux MR3, Installation Instructions Manual

STEP 1.

Remove the bottom-left pre-installed M6 x 16mm Hex Cap Screw.

STEP 2.

Install bracket on MR luminaire as shown using supplied M6 x 20mm 

Hex Cap Screw. Torque M6 x 20mm Hex Cap Screw to 40 in-lbs (4.5 

Nm). It is strongly recommended that a medium or high strength 

thread-locker be used when installing the bracket. For units using 

surface or suspension mounting, install safety kit hardware on top of 

the surface mount or suspension mount brackets in the same location 

as shown.

STEP 3.

Attach stainless steel chain to safety kit bracket using stainless steel 

oval shaped threaded connecting link.

STEP 4.

Attach loose end of chain. Secondary safety mounting point must be 

suitable for supporting a minimum of 50lbs:

-  Attach loose end of stainless steel chain to fixed eye-bolt (not 

supplied) using the second stainless steel oval shaped thread-

ed connecting link.

-  Alternate attachment method: Wrap loose end of chain 

around fixed beam or other immovable support and create a 

closed loop using the second stainless steel oval shaped 

threaded connecting link. Supporting beam or structure must 

form a closed loop to prevent the secondary safety chain from 

slipping off or becoming unhooked.

MR-SK-##

PART NAME

QTY

1

1

1

2

1

Secondary Safety Bracket

M6 Flat Washer

M6 x 20mm Hex Cap Screw

Oval Shaped Threaded Connecting Link

Stainless Steel Chain, 1/8” Trade Size

MR-SK-## – SECONDARY SAFETY KIT (Ordered Separately)

This MR-K-## kit is intended for use with UL Listed MR luminaire as 

marked on the luminaire nameplate.  

Accessory Package Contents

INSTALLATION STEPS

Step 2

Step 1

1

2

3

M6 SCREW

TM

Nemalux

I N D U S T R I A L

MR-GEN

rev. A-15

1-1

www.nemalux.com  |   sales@nemalux.com  |   Tel 403•242•7475  |   Fax 403•243•6190 

MADE IN CANADA