Part 2 Technical Manual Of Motherboard
33
USB Hardware Delays and Time-outs:
USB Transfer Time-out
Use this item to set the time-out value for control, bulk, and interrupt
transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device Reset Time-out
Use this item to set USB mass storage device start unit command
time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device Power-up Delay
Use this item to set maximum time the device will take before it properly
reports itself to the host controller.
The optional settings: [Auto]; [Manual].
‘Auto’ uses default value: for a root port it is 100 ms, for a hub port the
delay is taken from hub descriptor.
Select [Manual] you can set value for the following sub-item: ‘
Device
Power-up Delay in Seconds’.
Device Power-up Delay in Seconds
The delay range is from [1] to [40] seconds, in one second increments.
Intel(R) I211 Gigabit Network Connection- XX:XX:XX:XX:XX:XX
Press [Enter] to view current network information and make further
settings in ‘
NIC Configuration
’
NIC Configuration
Press [Enter] to configure the network device port.
Link Speed
Use this item to specify the port speed used for the selected boot
protocol.
The optional settings are: [Auto Negotiated]; [10 Mbps Half]; [10 Mbps
Full]; [10 0Mbps Half]; [100 Mbps Full].
Wake On LAN
Use this item to enable the server to be powered on using an in-hand
magic packet.
Blink LEDs
Use this item to identify the physical network port by blinking the
associated LED.
Intel(R) I211 Gigabit Network Connection- XX:XX:XX:XX:XX:XX
Press [Enter] to view health status for the drivers/controllers.
