Version: 2.0
KEN002PW18 25.11.2019
[ EN
●
12 ]
The wind affects the operation of the fireplace also indi
-
rectly by creating zones overpressure and depression
as well as the outside but inside the home. In areas
directly exposed to the wind (2) can create an internal
overpressure which can promote the draft of stoves and
fireplaces, but may be countered by external overpres
-
sure if the chimney is placed on the side exposed to the
wind (1). In contrast, in areas opposite to the direction
of the wind (3) can create a dynamic depression that
comes into competition with the natural thermal depres-
sion developed by the fireplace, but can be compensa
-
ted (sometimes) by placing the exhaust duct from the
side opposite to the direction of the wind (4)
1
2
3
4
1-2 = ZONE IN OVER PRESSURE
3-4 = ZONE IN DEPRESSION
WIND
The operation of the pellet stove is noticeably sensitive to the conformation and position of the flue
which is adopted. Hazardous conditions can only be overcome by suitable setting-up of the stove
carried out by qualified personnel.
IMPORTANT!
The connection of the stove to the hydraulic system must be made ONLY by qualified personnel and
can perform the installation in "ART" and in compliance with all statutory and regulatory provisions
in force and not in the country of installation. If the installation of the stove requires interaction with
another existing facility complete with another heater (gas boiler, gas boiler, oil boiler, etc...), is recom
-
mended for more qualified personnel who can then be challenged to answer the Full compliance of the
system, per the applicable law, and issuing the certificate. Nemaxx disclaims any liability for damage
to persons or property or in the event of failure or improper operation, if not complied with the above
warnings, and issued the necessary certificates of compliance enforcement work in an appropriate
manner. It is absolutely necessary that the network is designed properly sized to dispose of all the heat
flux produced by the stove to avoid raising the temperature inside the boiler.
IMPORTANT!
2.10 HYDRAULIC CONNECTION
Summary of Contents for PW18
