NEMCO FOOD EQUIPMENT
301 Meuse Argonne, Hicksville, OH 43526
1-800-782-6761 Toll Free 419-542-6690 Fax
www.nemcofoodequip.com 49206
3
INSTALLATION INSTRUCTIONS
IMPORTANT:
The 3 Shelf Humidified Merchandiser must be installed on a clean, flat surface capable of supporting
the merchandiser. The approximate weight of the merchandiser is 205 pounds when completely filled with water.
IMPORTANT:
The 3 Shelf Humidified Merchandiser
MUST BE
used with
4” leg or sealed directly to countertop using
the supplied gasket and/or an NSF 51 listed silicone to countertop as required by local Health Department. The
merchandiser
MUST BE
sealed to the surface using an NSF 51 listed silicone if food product is being prepped on the
same surface as the merchandiser is installed onto.
IMPORTANT:
When the merchandiser is turned on for the first time, allow the unit to run for approximately an hour to
allow the elements to burn off. If the unit is plugged into a GFCI, it may reset the GFCI during this time.
1. Remove all the packaging from the exterior of the merchandiser.
2. Set the merchandiser on a clean, flat surface capable of properly supporting the merchandiser weight. IMPORTANT:
Do not slide the merchandiser as it may damage the gasket.
3. Remove the fluorescent light bulb from the box and install into the top of the unit.
4. Remove the racks from the box and place into the unit as marked on the packaging. NOTE: The dip in the front of the
top two racks is to be located at the front of the merchandiser.
5.
Install the drain tube kit onto the rear drain tube on the back of the merchandiser using a ¾” wrench. (Figure #1)
Note: All male threads will need thread tape applied to seal the connection.
6. Install the drain tube holder by removing the (2) Phillips head screws mounting the rear sign bracket in place above
the drain (Figure #2
– A). Place the drain tube holder between the rear sign bracket and the rear panel align the
holes in the tube holder and the sign bracket (Figure #2
– B). Re-install the (2) Phillips head screw back into the
original holes (Figure #2
– A).
7. Clean thoroughly using a mild detergent and warm water before first use.
8. Plug the merchandiser into a certified electrical outlet with a corresponding voltage rating as listed on the Data Tag
and turn the merchandiser on.
9. Fill the merchandiser with approximately 2-1/2 gallons (10 quarts) of water until the green fill light turns on.
10. Allow the merchandiser to preheat and run for approximately one hour to allow the elements to burn off prior to first use.
NOTE:
If the unit is
plugged into a GFCI outlet, it may reset the GFCI during this time.
11. If unit fails to work properly when first operated, call NEMCO customer service at 1-800-782-6761.
B
A
A
FIGURE #1
FIGURE #2
Summary of Contents for 6470
Page 1: ......
