Page | 9
P: 419.542.7751 F: 419.5426690 800.782.761 nemcofoodequip.com
49233A
Troubleshooting/Error Codes
Flashing
Display
Indication
Cause
Solution
U
No pan or non- induction pan
Place an appropriate pan on the
cooktop target
1
Over current
Check for abnormal conditions like
water, moisture or broken parts or
cord. Unplug the unit. Plug it back
in. If the error continues, contact
customer service.
2
Over Voltage
Check to verify that the outlet voltage
is correct and within limits. Unplug
the unit. Plug it back in. If the error
continues, contact customer service.
3
Under Voltage
Check to verify that the outlet voltage
is correct and within limits. Unplug
the unit. Plug it back in. If the error
continues, contact customer service.
4
Main Heat Sink Over Temp
Check to verify that the fans are
working. Check to make sure the air
flow is unrestricted.
5
External Temp. Probe problem
Temp mode not available on BKT
series.
6
Pan is Overheated
Make sure the pan is not empty.
Allow the unit to cool down.
7
Power Frequency is Unstable
Check the incoming power for
frequency stability. Unplug the unit.
Plug it back in. If the error continues,
contact customer service.
8
OP Amp Offset Error
Unplug the unit. Plug it back in. If
the error continues, contact customer
service.
9
Main Coil Overcurrent
Unplug the unit. Plug it back in. If
the error continues, contact customer
service.
