Extended Wingspan 6" (Designed to support Larger Diameter props, more sensitive Pitch then Roll) :
Extend arms out to their full length. Swing arms out until arms are past the H configuration and the outside edge
hole on the top, bottom, and arm align perfectly where the blue circles are shown. To stiffen the frame in 6"
configuration it is required to insert an m3 spacer in the gap where the purple circle is and bolt it down with m3 x
8-12mm screws and a standard or nylock nut.
Also recommended to solid mount this configuration by putting an m3 x 8mm-12mm screw through the blue hole
and affix the bottom with a standard or nylock nut.
Summary of Contents for 240 FPV
