Removing a Battery from the Drill
1.
Set the rotational direction switch to the middle position.
Caution: To minimize the risk of accidental activation,
always ensure the rotational direction switch is in the
neutral (middle) position before performing any
maintenance work on the drill, as well as during
transportation and storage.
2.
Rotate the locking ring counterclockwise. The locking ring holds
the battery pack in position and prevents it from detaching.
3.
Pull the battery pack out and down, without exerting any force.
Inserting a Tool into the Drill
The drill spindle is locked whenever the On/Off trigger is not
pressed. This ensures quick, convenient, and easy changing of the
tool in the keyless chuck.
1.
Set the rotational direction switch to the middle position.
Caution: To minimize the risk of accidental activation,
always ensure the rotational direction switch is in the
neutral (middle) position before performing any
maintenance work on the drill, as well as during
transportation and storage.
2.
Ensure that the On/Off trigger is not pressed.
3.
Turn the chuck sleeve counterclockwise until it is open wide
enough to fit the tool.
4.
Insert the tool into the chuck, placing it as far as it will go.
5.
Firmly tighten the chuck sleeve by hand, clockwise, to tighten
the chuck.
6.
To remove the tool, loosen the chuck sleeve counterclockwise
until the tool is free.
9
