Hardware Installation
The
NEMTEK Connect DG
has been designed to be installed onto the battery brace inside
of the enclosure of a supported NEMTEK energizer.
To install the DG, unplug the energizer from mains and disconnect the energizer’s battery
leads from the battery. You may need to remove the battery brace to get better access to
the battery terminals to remove and plug in the cables onto the battery terminals.
Plug the energizer battery leads directly into the
Battery Power Out
terminals of the DG
board. Be careful to ensure you connect the correct polarity wires to the correct terminal.
Make sure the terminal connectors are plugged in completely and firmly onto the battery
terminals on the board.
Connect the furthest away battery wire to the battery. This is usually the negative terminal
and wire, unless the battery is orientated differently. Take care to ensure you connect the
correct polarity wires to the correct battery terminals. Do not connect the second wire yet,
as this will apply power to both the DG and energizer.
Make sure the battery is firmly in place and screw the battery brace back over the battery.
Be sure that no wires or obstacles are between the battery brace and the battery and that
the battery brace goes over the battery without any force, otherwise this may cause a crack
in the battery which could cause a leak of battery acid.
Align and screw in the DG board on the battery brace. Two screws are supplied for this
purpose.
Screw in the antenna. If your antenna has a lead, make sure it is routed outside of the
enclosure via the appropriate cable management ports, be careful to not get the cable caught
on the enclosure edge when screwing the lid back on.
Connect up the DG to your energizer as is necessary (see following section for details for
each of the supported Nemtek products).
Once everything is wired up and setup, plug in the second lead to the battery to power up
the system. Screw the lid of the enclosure back into place and plug the energizer back into
the mains. Reconnect the mains supply.
www.nemtek.com
3
