Place the transformer upright and ensure that it is free and well ventilated on all sides. Do not place
the transformer on a thick carpet.
Tips
When you place your projector, note the following information.
Experiment what the best place is for your projector, with these dimensions in mind:
Distance projector to wall:
Diameter projection:
The greater the distance, the greater and better the projection. The darker the room and the lighter
the wall, the better the projection. The projector should be positioned at least so high that nobody
can look directly into the lens.
Keep the space between the projector and the wall empty to prevent silhouettes. The distance from
the socket to the on / off button on the cable is approximately 225 cm. The distance from the
transformer to the projector is approximately 175 cm.
Both the transformer and the projector must be positioned so that air can enter on all sides - the
projector becomes hot during use - do not place in the vicinity of flammable materials. Use the on /
off button regularly.
9. In use
To change the angle of the projector, turn the round part of the projector (C) into the base (D).
Effects are best seen on a white or light wall / ceiling. The brightness and size of the projection
depend on how much light is in the room (the darker the room, the better) and the distance to the
wall. Turn the focus lens (A) to adjust the sharpness. Use the projector for up to 6 hours at a time.
After use, remove the plug and let it cool down before replacing the object.
Liquid wheel (17461)
The liquid wheel has a diameter of 10 cm and is 9 mm thick. When the fluid in the fluid wheel
becomes warm, the projected effect changes. Do not shake the fluid wheel. Do not expose the fluid
wheel to direct sunlight. Handle the fluid wheel with care - fluid wheel is made of glass. Only touch
the rubber edge.
10. Maintenance
