20
1.
Nebuliser (main unit)
2.
Air tube
3.
Air duct
4.
Power switch
5.
DC socket
6.
Medication container (set)
7.
Medicine container holder
8.
Air filter cover
9.
Pads
10.
Power cable
11.
Medicine container cover
12.
Inner lid for medication
13.
Connector
14.
Medicine container
06. INSTALLATION
Make sure the mouthpiece/mask and air filter are clean before use.
•
Clean and disinfect medicine container, mouthpiece, masks before first use.
•
If the device has not been used for a long time or if more than one person uses
the same device, clean and disinfect the container before use.
•
Make sure the air filter is clean. If the air filter has changed colour or has been
used for more than 60 days, replace it with a new one.
1.
Connect the power supply to the DC socket of the nebuliser and then to the
power socket.
SEE FIG. D. 1
2.
Remove the cover of the medication container.
SEE FIG. D. 2
3.
Carefully lift the inner lid and fill the medication container with the correct
amount of medication.
SEE FIG. D. 3
4.
Fix the inner cover by gently turning it clockwise, then attach the cover.
SEE FIG. D. 4
5.
Attach mouthpiece or mask.
SEE FIG. D. 5
6.
Twist the air tube plug and push it firmly into the nebuliser air tube
connector. Twist the air tube plug slightly and press it firmly into the air tube
connector at the bottom of the medication cup.
SEE FIG. D. 6
NOTE:
Hold the medication container in
an upright position when fitting the air
tube.
The nebuliser has a handle to hold the medication container vertically.
SEE
FIG. D. 7
07. INSTRUCTIONS FOR USE
1.
Hold the medicine container as shown.
Do not tilt the medicine container at an angle greater than 45°.
Otherwise,
Summary of Contents for Sano
