Operation
Instructions
1. Installing Bits
1).The bit inclinedly insert
into the nozzle top
,
2).Then push the bit into chuck
horizontally.
3.Uninstalling Bits
1).Press the chuck and pull
out of bit horizontally,
2).Then inclinedly pull out of
the bit from nozzle top.
2. Finished Installation
II.
Installing and
uninstalling
Bit
4
Nozzle Top
Chuck
Summary of Contents for NZ30-01
