neo-tools.com
neo-tools.com
8
•
Insert 3 new AA batteries, observe correct polarity indicated on the battery lid with +/- symbols.
•
Close the battery lid, make sure the latch snaps in place.
"Pulse" feature changes laser beam frequency, using it is recommended in sunlight. Depending on ambient
conditions (light intensity, colour and roughness of the surface the laser is projected to), this feature on or off may
improve laser visibility.
USE OF MAGNETIC HOLDER
•
In order to attach the cross line laser to the magnetic holder, drive the threaded pin (
2
) into stand thread in the
laser base, use the wheel (
1
).
•
The wheel (
1
) allows to set the cross line laser to the right or left.
•
The knob (
3
) allows to set the cross line laser up or down.
•
The magnets (4) allow to attach the stand to metal surfaces.
•
The holder is equipped with stand threads ¼" (
5
) and 3/8" (
6
).
HOW TO OPERATE THE LASER – SELF LEVELLING FEATURE
The laser offers self-levelling feature. The feature is operational within ±4° of the laser tilt.
•
Switch the laser on, slide the self-levelling lock switch (
1
) to unlocked position.
•
When the laser angle does not allow the self levelling feature to work (greater than 4°), the laser will signal the
problem by intermittent sound, laser flashing and battery level indicator diode flashing.
•
Set up the laser so it does not signal incorrect position, only then it will be possible to set vertical and horizontal
line.
•
Press the feature toggle button (
2
) to toggle between showing horizontal line, vertical line and both.
•
Line visibility can be improved with the "Pulse" feature. To switch this feature on, press the button (
3
).
•
To switch the laser off, slide the self-levelling lock switch (
1
) to locked position.
HOW TO OPERATE THE LASER – LASER LOCK FEATURE
The laser lock feature allows to project straight lines at any chosen angle.
•
Leave the lock switch (
1
) in locked position.
•
Press the Pulse button (
3
) to switch the laser on.
•
Press the Pulse button (
3
) again to toggle between showing horizontal line, vertical line, both lines and
switching the device off.
ORIGINAL-BEDIENUNGSANLEITUNG
KREUZLASER
75-101
ACHTUNG: Lesen sie die vorliegende Betriebsanleitung vor der Inbetriebnahme dieses Gerätes
sorgfältig durch und bewahren sie diese für späteres Nachschlagen auf. Die Nichtbeachtung der
Sicherheitsregeln kann zu Schäden am Gerät und zu Verletzungen führen.
WARNUNG: Nicht direkt ins Laserlichts schauen!
