B
-24
NEO Hand-Held with Windows Mobile 6.1 Classic User Manual
Appendix B: Teklogix Imagers Applet
Options
B.5.1
Options
Auto Retry On Failed Decode Enabled
Setting this parameter to
on
allows the imager to repeat the image capture attempt if the
initial attempt fails. The number of retries is dependent on the value assigned in the next pa-
rameter,
Max Number of Auto Retry
. If this parameter is set to
off
, the imager will only
attempt the image capture once.
Max Number of Auto Retry
The value assigned for this parameter governs the number of times the imager will attempt
to capture a bar code if the first attempt fails to a maximum of
99
times.
Decoder Timeout
This parameter determines the maximum time that the decoder will spend searching for a
bar code on a captured image. The value assigned here is dependent on the type of bar code
and quality of the image being captured. For example, the value may need to be increased to
compensate for larger bar codes with more data encoded or for poor quality images. On the
other hand, the value can be decreased for smaller, good quality images. The allowable
value ranges from 200 to 500 msec.
Single Target Mode Enabled
When this parameter is enabled, the decoder assumes that a single bar code exists in the
image and that it is located in the centre of the image.
Add AIM ID Prefix
The
AIM ID
(Association for Automatic Identification and Mobility) is an international bar
code identifier. When this parameter is enabled, the
AIM ID
is inserted at the beginning of
the decoded bar code.
B.5.2
Code 39
Enabled
Setting this parameter to
on
makes “Code 39” readable to the imager.
Note: Remember that if you want to
edit
the symbologies, the preset you want to
change must be active. Highlight the
preset
you want to edit, and tap on the
Activate
button – an
A
is added at the far right of the preset. With the activated
preset highlighted, double-tap on the
Edit
button.
