C
-6
NEO Hand-Held with Windows Mobile 6.1 Classic User Manual
Appendix C: Bar Code Settings
Code 39
Delete Char Set ECIs
Setting this parameter to
on
enables the scanner to delete any escape sequences representing
Character Set ECIs – Extended Channel Interpretations (also known as GLIs) from its buffer
before transmission.
When this parameter is enabled, the scanner transmits data from PDF417 and MicroPDF417
bar codes containing Character Set ECIs, even when the ECI Protocol is disabled.
ECI Decoder
Setting this parameter to
on
enables the scanner to interpret any Extended Channel Interpre-
tations (ECIs) supported by the scanner. This parameter has no effect on symbols that were
not encoded using ECIs.
If this parameter is set to
off
and a symbol that was encoded using an ECI escape is scanned,
the scanner transmits the ECI escape followed by the uninterpreted data.
C.2.5
Code 39
Enabled
Setting this parameter to ‘on’ enables “Code 39”.
Enable Trioptic Code 39
Trioptic Code 39 symbols always contain six characters. Setting this parameter to
on
allows
this type of symbology to be recognized.
Convert To Code 32
Setting this parameter to
on
allows the scanner to convert the bar code from “Code 39”
to “Code 32”.
Code 32 Prefix
Note: “Trioptic Code 39” and “Full ASCII” should not be enabled simultaneously. The
scanner does not automatically discriminate between these two symbologies.
Note: “Code 39” must be enabled in order for this parameter to function.
Note: “Convert to Code 32” must be enabled in order for this parameter to function.
