For example: we can see the above picture which has a rectangular block and a circular block to form a small panel. We call
such panel as submodule. We can generate the whole panel board through creating a submodule. The whole panel board has
4 panels consisting of 2 rows and 2 columns. Align the 3 head components(right top,left top and left bottom), then generate
the submodule, the submodule is shown in the figure.
We also can select stack, nozzle, name, specification and etc. to adjust in this page.
Two ways to generate submodules: rectangle and circle.
①
The way to generate rectangle panel: Click: ‘submodule’, below dialogue will pop up. Please fill in specification and
footprint of component. We can see the panel has four rows and five columns. Fill in 4 rows and 5 columns in the
dialogue, and align the three components(right top, left top, left bottom). The component degree will be based on actual
situation. Click ‘create’, the machine will generate all the coordinate automatically.
23
Zhejiang
NeoDen Technology Co.,Ltd.