Neogen Corporation Electro Jac 6, Operator'S Manual

Questions? Call us at 800/621-8829 or 859/254-1221

12

Questions? Call us at 800/621-8829 or 859/254-1221

13

IMPORTANT:

Always check the unit for shipping damage immediately after receipt from 

repair. Shipping damage normally is the responsibility of the carrier. If ElectroJac 6 has been 
damaged during shipping, inform the carrier immediately, and call Neogen’s Electronics 
Department at the number above.

Authorized repair center

ElectroJac 6 carries a 12-month limited warranty on defective materials and workman-
ship. All products covered under this warranty are to be returned, freight prepaid.

Warranty

ElectroJac 6’s fuse is 
located above the battery 
in the battery compart-
ment.

Fuse replacement

1.  Remove the dwell cable (if used) and the probe cable.
2.  Unlatch the battery compartment. 
3.  Tip electronics case upside down to view the electronic 

circuit board.

4.  The fuse should be visible near the center of the lower 

edge of the electronic circuit board.

5.    Remove blown fuse and replace with a new 5 x 20 mm, 

4 amp, Fastblow Littlefuse brand (item 235004), or 
equivalent.

6.  Replace the top of the electronics case onto the battery 

compartment and latch the two sections together.

Neogen Corporation
Attn:  Electronics Department 
944 Nandino Blvd.
Lexington, KY 40511 
800/525-2022 or 859/254-1221