Number of unsuccessful Requests before Action:
In this field, define the number of Port scanning commands to be sent to the IP device before executing
the actions.
The number can be set between 1 and 65535 seconds.
Delay before First Request after Action:
In this field, define the time in seconds before restarting the monitoring after the reboot action.
The delay can be set between 30 and 65535 seconds.
Maximum Number of Actions
In this field, define the maximum number of actions.
The number can be set between 0 and 255.
Configuring the Actions
For the Event defined above, you can choose and configure following actions:
Set Power Outlet:
Check this box and in the corresponding drop-down list, choose the power outlet the rule will apply to. In
the next corresponding drop-down list, choose the action to execute. Each power outlet can be switched
On/Off and restarted. If you choose "restart" you will also be able to define a restart delay between 0 and
65535 seconds.
- If you choose 0 second, the delay will be the delay defined in the ePowerSwitch power outlets settings.
- If you choose a delay different from 0, the delay will replace the delay defined in the ePowerSwitch
power outlets settings.
Send Syslog Message:
This type of action can be configured only if you have already created at least one destination
Syslog Server (Misc/Log Settings Tab).
Check this box if you want to send a message to a Syslog server. In the following drop-down lists choose
the facility and the severity of the message to send. The address of the Syslog server has to be defined in
the "Log Settings Page".
Send Trap Message:
This type of action can be configured only if you have already specified at least a destination
SNMP Server (General/SNMP Tab).
Check this/these box(es) and specify one or two SNMP addresses in the corresponding field if you want to
send SNMP messages to one or two SNMP Servers.
Syslog / Trap Message:
This field can only be used if you have already specified at least one destination Syslog Server
(Misc/Log Settings Page) or one destination SNMP Server (General/SNMP Page).
Up to 255 characters may be entered in this free text field. The text will appear in the Syslog and the Trap.
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.
32
