37
Problem / Troubleshooting
y
If you choose any setting that is already in use by another
Digital Input Module
connected to the
ePowerSwitch 8M+
R2
, a conflict occurs and the corresponding Edit and Info symbol of the previous
connected
Digital Input Module
will be changed to black. In that case, disconnect your last connected
Digital Input Module
, remove its power adapter(s), change the DIP switch settings to solve the
address conflict and reconnect it again. If the conflict is solved, all connected devices will now appear
on the Peripherals page and their Edit and Info Symbol will be red.
y
The Peripheral page is not automatically refreshed, so you need to refresh it by clicking the peripheral
TAB again (or push [F5] or press <CTRL-R> on your keyboard if you use Internet Explorer or Mozilla
Firefox).
To configure or modify the settings of the Digital inputs, click on the corresponding "Edit" button in the
Peripherals page.
A new page appears, allowing you to set all the parameters of the Digital Inputs.
ID:
The ePowerSwitch 8M+
R2
automatically creates an ID Code to clearly identify each connected Digital Input
Module.
•
DIM followed by a number identifies each Digital Input Module
Name:
In this field, enter the name you want to give to the Digital Input Module. The name can be from 1 to 32
characters long, and can contain alphanumeric characters.
Do not use quotes or special characters in labels!
Activated
This check box must be checked to activate the device and enables to deactivate it temporarily while
keeping all its settings for a later use.