Neomatica. LLC. Tracker ADM50 GLONASS / GPS. Rev.1.2 dated 03.10.2018
8
DMODE X
X=0
– Beacon Mode, X=1 – Tracker Mode
5.1 Beacon Mode
In the beacon mode, the ADM50 is periodically in the active state, performs certain actions,
such as: determining coordinates, waiting and processing incoming SMS, and others, and
between activity states the tracker is in the sleep state (energy saving).
Beacon mode setting commands:
BTIME X,Y,Z,A
X
– minimum activity time;
Y
– maximum activity time;
Z
– sleep time after successful activity;
A
– sleep time after error,
Where X, Y, Z, A sets in seconds.
•
minimum activity time - the time during which the ADM50 will guaranteed be in the active
state, even if all the necessary actions were performed. This time allows to wait for an
incoming SMS containing the command;
•
maximum activity time
— the time after which the ADM50 will go to sleep, even if it didn't
not perform all the necessary actions, for example, determine the coordinates or send data
to the server;
•
sleep time after successful activity
— the time for which the ADM50 will be in sleep state, if
all the necessary actions were performed during the ADM50 activity;
•
sleep time after error
— the time for which the ADM50 will be in sleep state, if during the
activity were not executed all the tasks or errors occurred, for example, it was not possible
to establish connection to the server.
BMODE X,Y,Z
X
– GSM module status during sleep: 0 – off., 1 – on.;
Y
– GLONASS/GPS module status during sleep: 0 or 1 – off.;
Z
– determination of coordinates during activity:
0
– Disabled;
1
– GLONASS/GPS;
