58
6.2.4
Folder
When a stoppage occurs in the Folder, remove the
documents from the Folder as follows:
1. Push the lower end of the locking handle
A
to
open the Folder cover
B
.
2. Remove the documents from the Folder.
3. Close the Folder cover.
4. Press
to reset the error and restart the
job.
6.2.5
Feeder
When a stoppage occurs in the Feeder, remove the documents from the Feeder as follows:
1. Pull the vertical transport hand grip upward to open the vertical transport cover.
2. Remove the documents.
3. Close the vertical transport cover.
4. Press
to reset the error and restart the job.
6.2.6
Collating Area
When a stoppage occurs in the collating area,
remove the documents from the collating area as
follows:
1. Lift and hold the collator arm
A
.
2. Remove the documents.
3. Lower the collator arm.
4. Press
to reset the error and restart the
job.
6.3
Operator Troubleshooting
To resolve problems:
1. Write down the error.
2. Try to solve the problem by consulting the troubleshooting table.
3. Switch the inserter off and on again, to verify system operation.
4. When the error still occurs contact your service organization.
A B
A
