Page F-1
APPENDIX F: ERROR MESSAGES
F.1 ERROR
MESSAGES
If the scale encounters an error condition caused either by the operator or the meter, the
scale will beep you and display a message alerting the operator. A description of each
display follows:
F.1.1 OPERATOR
ERRORS
Invalid Destination
Indicates that service selected is not available for the
destination.
Invalid Country
Indicates that an invalid country code was entered
Invalid Service
Indicates that an invalid add-on service was selected
Overweight
Indicates that the weight for the class of service or
international destination selected has been exceeded
Scale Wt Exceeded
Indicates that the weighing capacity of the scale has
been exceeded
No Rate Selected
Indicates that a rate must be selected before the given
operation
Invalid Entry
Indicates that the selected function, service or rate is
invalid.
Lowest Rate Not
Setup
Indicates that the lowest rate key has not been
enabled.
Memory Full
All of the available memory for the Memory keys has
been used.
F.1.2 METER
ERRORS
Error Solution
No send Response
Franking machine not in remote mode or
disconnected.
Low Credit
Indicates that the meter requires recrediting.
Meter Busy
Franking machine was being used for another
activity.
No
Label
Franking machine connected does not have label
facility
Out of Labels
Franking machine has run out of labels
Base not on
Franking machine base not on
Failed to set
Franking machine not set
Checksum Error
Correct value not set on franking machine
Send Failure
Transaction not completed by franking machine
