SI 72
24/33
Fig. 50
Fig. 51
Fig. 52
A
7. FAULT FINDING
7.1 General
In the SI 72 the following error types are possible:
• paperflow errors,
• technical errors.
If an error occurs the display shows a screen with an error
description and a suggested solution.
When a paperflow error occurs the display shows a screen
as in fig. 50 (for example). The menu shows the following
functions:
• show more information (key 1),
• reset the error after solving the problem (key 6) (the
error screen will disappear).
The black arrow or a black feeder indicates where the
problem occurs.
For a complete description of error codes see section 7.3
on page 26.
When there is a technical problem the display shows the
message in figure 51.
This error cannot be solved by operating personnel and
assistance of the service support is needed.
First switch the inserter off and on again, to verify machine
operation. When the error still occurs write down the error
code and contact your service organisation.
Warning screen
The display shows a warning screen with the message
“Cover open” and a suggested solution “Close cover”,
when a cover is opened.
7.2 Clearing stoppages
Exit and sealing area
When a stoppage occurs in the exit and sealing area,
remove the material as follows:
• open the side cover A (fig. 52),
• lift the locking lever B (fig. 52) of the loc and pull the
loc up into the vertical position,
• remove all material,
• lower the loc and close the side cover.
Reset the error after solving the problem with (key 6) (see
fig. 50).
Key
Key
