SI 72
8/33
• loosen the knob B half a turn (fig. 14),
• grab the side guides in the middle and push them apart
as far as possible,
• put a small stack of documents between the side guides.
• grab the side guides in the middle and push them
towards the documents,
The space between the side guides and the documents
should be such that the documents have just enough
play to move freely,
• re-tighten knob B,
• remove the stack of documents.
Replace the document feeding tray as follows:
• place the document feeding tray under guide A (as
shown in fig.15),
• push the document feeding tray up and then lower it
into position.
Fig. 14
4.5.3 Filling the document hopper
Open the left side guide B (fig.12) by turning it
downwards. The feed rollers will automatically be lifted.
Place a stack of documents between the side guides. Turn
the left side guide upwards again.
Feed the documents (depending on the type of documents
and the type of fold) as shown in 4.7 Feeding documents
page 9.
Fig. 15
4.6 Adjustment of the document stoppers
The position of the document stoppers can be adjusted
according to the longest document used (the document size
is programmed in jobs).
Initially the document stoppers are set to position B. In this
position a wide variety of documents can be handled and
adjustment is not needed.
To adjust the stopper position lift and hold the collator arm
D, squeeze the stopper and pull the front side tab up. To
replace the stopper first place the flat back tab into the
slotted hole and then push the stopper into position.
For use of small documents of about 148,5 mm
(5.8 inch) or smaller, the four document stoppers must be
set in the first position (position A).
For use of longer documents, maximal 356 mm (14 inch),
the four document stoppers must be set in last position
(position C).
The position of the document stoppers is set by service
personnel according to the document sizes programmed in
the jobs.
Fig. 16
A
A
B
C
D
