POC-300 Series
70
3.7
Powering On the System
There are five methods to power on the system
Pressing the power button
Via an external non-latched switch
Via an external latched switch
Sending a LAN packet via Ethernet (Wake-on-LAN)
Using the ignition signal input (if MezIO-V20 is implemented)
We will describe the processes and actions involved for the first four methods in this
section and the ignition signal input method will be described in section 3.8.
3.7.1
Powering On Using the Power Button
This is the simplest way to turn on your system. The power button on the front panel
is a non-latched switch and behaves as the ATX-mode on/off control. With DC power
connected, pushing the power button will turn on the system and the PWR LED
indicator will light up. Pushing the button when system is on will turn off the system. If
your operating system supports ATX power mode (i.e. Microsoft Windows or Linux),
pushing the power button while the system is in operation will result in a pre-defined
system behavior, such as shutdown or hibernation.
Summary of Contents for POC-300
