Nuvo-6108GC/ Nuvo-6108GC-IGN
78
3.5.2
Powering On Using Wake-on-LAN
Wake-on-LAN (WOL) is a mechanism to wake up a computer system from a S5
(system off with standby power) state via issuing a magic packet. The system’s
Wake-on-LAN compatible GbE port is shown below.
NOTE
Please make sure the Intel chipset and Ethernet driver has been properly
installed prior to setting up WOL function.
To enable WOL function, please set up WOL settings in the BIOS and in the
operating system by follow the steps described below.
1.
When the system boots up, press F2 to enter BIOS setup utility.
2.
Go to the
[Power]
>
[Wake On LAN]
and set it to
[Enabled]
.
3.
Press F10 to “
Save changes and exit BIOS
” and allow the system boot into