SKE4-E Steam Humidifier
Installation Instructions and User Manual
Page | - 45 -
Idle Screen
When the controller is in operation, the unit displays the following information on the Idle Screen:
Table 12 - Idle Screen Display Description
Setting
Default
Range
(
* indicates no configuration; display only)
Description/Notes
HumDemand:
Current value
* (min: 0.00%, max: 100.00%)
Displays the current humidity demand
value.
ControlState:
Current value
* (Off, Normal, LowLimit, HighLimit,
NoAirFlow, Interlock)
Displays the current state of the safety
control circuit and whether the circuit has
been disconnected due to a safety
switch.
PowerOutput:
Current value
* (min: 0.00%, max: 100.00%)
Displays the measured power output of
the system as a percentage of the total
power.
State:
Current value
* (Off, Idle, LineRinse, TankRinse, Filling,
Draining, Heating, Boiling, Alarm)
Displays the current state of operation of
the humidifier.
Illustration 49 - Idle Screen Display
Menu Access
x
From the Idle Screen, the Main Menu can be accessed by pressing the Back/Menu button ,
enabling access to the General menu.
x
To view other menu options and perform configurations to the system, press Enter while on
the Idle Screen to advance to the Login Screen, where a valid password must be entered.
x
Four different passwords can be used, each granting access to an additional menu option
depending on the access level assigned to the provided password.
x
If a password of higher access is provided, all menu options accessible with the use of a lower
level password will also be unlocked.
Table 13 - Access Levels
Access
Level
Password
Menu Unlocked
Description/Notes
1
None
General
Grants access to General menu.
2
2222
User
Grants access to General and User menus.
3
3322
Service
Grants access to General, User and Service menus.
4
4433
Installation
Grants access to General, User, Service and Installation menus.
5
5544
Integration
Grants access to General, User, Service, Installation and Integration menus.
Note: To modify or retrieve lost passwords, please contact factory.
