SKE4 Steam Humidifier
LonWorks Integration Manual
www.neptronic.com
Page | 3
LonWorks FTT Module Installation
1.
Before beginning installation, remove the power supply to the humidifier at the disconnect switch or the
breaker.
2.
Open the access door to the low voltage compartment, located on the top right side of the cabinet, by
using the humidifier access key.
3.
In the low voltage compartment, remove the nuts that are attached to the printed circuit board at the two
locations indicated below, and set them aside. Add the two nylon standoffs (supplied) onto these two
locations.
