11
Betriebsanleitung Neptun Massagestation Edelstahl V.20181005
installation
Delivery contents in accordance with fig. 1 except gate valve, block- off set and all pipings.
The installation can take place according to the customers` request (the position of the massage
nozzles). The mounting parts for the massage nozzles can be installed as required. The given di-
mensions are only suggestions. For longer lines, the pipes should be enlarged by one dimension.
The installation kit for the massage station must be covered with the enclosed building protection
so that all threads are protected. Please mind the installation arrangement.
mounting of the flat gasket to the built-in pot
DThe site of the pump must be chosen as close as possible to the installation kit. In addition,
make sure that the pump is mounted voltage- and vibrationfree on solid base or a suitable panel.
Furthermore, you have to provide an outflow possibility as well as an adequate ventilation to pre-
vent a flooding of the site. That`s the only way how a trouble-free operation can be guaranteed.
The air valve must be mounted vertically upwards and above the water surface. All the pipe fit-
tings, required for a scheduled piping, are included. Should, however, extensions may be neces-
sary, keep the pneumatic hose as short as possible (max. 4 m), and don`t crincle or clamp it in
any way. In addition, make sure that in case of modified piping, only bends and 45° T-pieces but
never angles must be used. Similarly, a piping of the next larger nominal size should be worth to
compensate possible pipeline resistors.
The pneumatic hose must be placed and fixed on the control box (fig. 1) If possible install the PN-
hose above the water level.
The Pneumatic hose must be placed on the control box (fig. 1) .
It has to be installed above the water level.
Massagestation Edelstahl_A4 14.12.18 08:57 Seite 11
