4. Connect the cable to the GPRS or Wi-Fi antenna before
connecting it to the base of the R450 DC. See Figure 20.
5. Tighten the coaxial cable connection to 14 in-lb.
(1.58 NM).
Figure 20 – Cable to GPRS Antenna
6. Connect the GPRS antenna cable to the base of R450 DC. See
7. Tighten to 14 in-lb. (158 Nm).
Figure 21 – GPRS Antenna Connection at Base
WARNING: Give special consideration when installing the
R450 DC is installed inside a building.
The screen (shield) of the coaxial cable must be connected
to earth (grounded) at the entrance to the building. Do this in
accordance with applicable national electrical installation
codes (Section 820.93 of the National Electrical Code,
ANSI/NFPA 70).
Soyez particulièrement attentif lorsque vous installez
l’enregistreur de données R450 à l’intérieur d’un bâtiment.
L’enregistreur de données R450 est installé à l’intérieur d’un
bâtiment. L’écran (blindage) du câble coaxial doit être
raccordé à la terre (mis à la terre) à l’entrée du bâtiment.
Procédez conformément aux codes nationaux d’installation
électrique applicables (section 820.93 du National Electrical
Code, ANSI/NFPA 70).
22
R450 Data Collector Installation and Maintenance Guide
Chapter 3: Installation of the R450 DC
Summary of Contents for R450
Page 2: ......
Page 3: ...R450 Data Collector Installation and Maintenance Guide ...
Page 8: ...This page intentionally left blank ...
Page 143: ......