CAUTION: Wiring the AC-power for the R450 DC must be
done by a licensed electrician. Install in accordance with the
National Electrical Code, Canadian Electrical Code, and
local electrical codes.
MISE en GARDE: Le câblage du circuit d’alimentation en
courant alternatif de l’enregistreur de données R450 doit être
effectué par un électricien qualifié. L’installation doit être
faite conformément au National Electrical Code, au Code
canadien de l’électricité et aux codes locaux de l’électricité.
To connect the AC power to the R450 DC, complete the following
steps.
1. With the key, open the door to the R450 DC.
2. Use a listed UL or CSA Type 4x conduit connector to thread
the AC cable through the bottom of the R450 DC unit as
illustrated in Figure 25.
Figure 25 – AC Wiring Threaded Through Base (120V AC Installation)
Connecting the AC-Power Wires
Connect the wiring for the AC-power in the R450 DC by completing
the following steps.
1. Attach the
black (L)
wire to the left breaker switch as illustrated
in Figure 26.
2. Torque the breaker screw terminal to 22 in-lb. (2.48 Nm).
Figure 26 – Attaching the Black Wire
R450 Data Collector Installation and Maintenance Guide
25
Chapter 3: Installation of the R450 DC
Summary of Contents for R450
Page 2: ......
Page 3: ...R450 Data Collector Installation and Maintenance Guide ...
Page 8: ...This page intentionally left blank ...
Page 143: ......
