AVERTISSEMENT: Un contact entre l’antenne et des fils à
haute tension peut entraîner la mort. Faites attention aux
lignes électriques aériennes lorsque vous érigez l’antenne et
le mât.
To mount the crossbar, complete the following steps.
1. Locate a position for the crossbar approximately 5 feet from the
base of the pole.
2. Attach the horizontal crossbar so that there is some overhang
past the end of the pole.
3. Using a 2-inch strut clamp, secure one end of the crossbar to the
vertical pole making sure the crossbar is perpendicular to the
pole. See Figure 40.
Figure 40 – Securing the Crossbar
Attaching the Antenna
After mounting the horizontal crossbar, you can mount the GPRS or
Wi-Fi antenna.
To mount the GPRS or Wi-Fi antenna, complete the following steps.
1. Locate a position on the crossbar approximately 2 inches from
the end. See Figure 41.
2. Using the 1-inch strut clamp, attach only the black band of the
modem antenna to the crossbar.
Figure 41 – Mounting the GPRS or Wi-Fi Antenna
R450 Data Collector Installation and Maintenance Guide
39
Chapter 3: Installation of the R450 DC
Summary of Contents for R450
Page 2: ......
Page 3: ...R450 Data Collector Installation and Maintenance Guide ...
Page 8: ...This page intentionally left blank ...
Page 143: ......