6. Remove the four screws from the mounting plate (this will remove
the mounting plate as well as the modem).
7. Attach the new mounting plate with the four new screws.
8. Attach the new modem to the new mounting plate with the
modem oriented so that the Ethernet cable port is on the left.
9. Reconnect the Ethernet cable, antenna cable, and the power cable.
See Figure 57.
Figure 57 – R450 DC with CDMA Modem Conversion Kit Installed
CalAmp CDMA Modem
Ethernet Cable Connection (2 of 2)
Ethernet Cable Connection (1 of 2)
Antenna Connection (1 of 2)
Modem Power Cable
Antenna Connection (2 of 2)
66
R450 Data Collector Installation and Maintenance Guide
Chapter 5: CDMA Modem Conversion Kit Installation
Summary of Contents for R450
Page 2: ......
Page 3: ...R450 Data Collector Installation and Maintenance Guide ...
Page 8: ...This page intentionally left blank ...
Page 143: ......