Adjust the R900
®
/ R900v2 / R900v3 Readings for EZ Route
This section is only for EZ Route users.
After you install and configure the N_SIGHT software, the first time you start N_SIGHT you are
directed to enter the initial setup values for your system so that it is ready for use. Refer to
Table 6 in the N_SIGHT Software Suite Getting Started Guide for a description of all the
values.
Neptune strongly recommends that you do not change the locations for the directories
created by the installation program.
Adjust R900 Readings is the option for an automatic adjustment of R900 readings. To enable
this adjustment, check this box on the N_SIGHT Initial Setup Values Dialog.
This option reads only the first set of digits depending on the number of dials set in the
Import file.
When this option is selected, the Adjust Dials option appears. This option allows you to set
the number of dials. This option is only available if you check the box for Adjust R900
Readings
Examples:
If the number of dials is set to four, then the system reads and returns the reading for the first
four digits. If the number of dials is set to a number higher than six, then the system drops
the trailing zeros.
The number of dials in the Import file should be set to adjust to the actual number of digits of
the register. If the number of dials is less than the actual reading digits, the readings have a
shortened number of digits and are not accurate.
R900® Belt Clip Transceiver Users' Guide
25
Appendix
A:
N_SIGHT
®
Meter
Reading
and
Override
Summary of Contents for R900
