Ensure the large
holes at the bottom
of each opposite leg
are furthest away
from you. This is
crucial so we can fit
the second pole at
the back of the frame
to attach the cover.
6.
With the frame upright and the legs opened, we are now going to fit the side
cross braces on the outside of the frame. See the photos below starting from left
to right.
Take one of the short bolts, place a washer over it and insert it through one end of
the cross brace as pictured and pass the bolt through the small hole
approximately halfway down either of the front legs. Once you have passed the
bolt through the cross brace and the leg, you will see the bolt appear on the other
side. Place another washer over the bolt. Take a dome nut and screw it onto the
end of the bolt and finger tighten it.
Now take the spanner and position it over the dome nut and hold the dome nut
and spanner still whilst tightening the bolt on the other side with the Allen key.
Repeat on the other end of the cross brace to complete it being fitted to the main
frame.
