© EUROHEAT DISTRIBUTORS (H.B.S) LTD. October 2012
E & OE Instructions Part number IN1264 Edition A
18
Removal of the Rear Protection Plate
To remove (1) lift up the plate so it is higher than the lugs on
the grate frame and then (2) draw it towards the centre of the
fire box.
As it is drawn towards the centre twist the edge towards the
front of the fire box. It can then be angled within the fire box
to withdraw it through the door.
To refit the replacement reverse the procedure.
Removal of the Grate
To remove (1) lift up the grate so it is higher than the grate
frame and then it can be withdrawn from the fire box.
To refit the replacement reverse the procedure (2) ensuring
that the lug on the bottom of the grate locates in the riddle
arm.
Removal of the Grate Frame
With the baffle plate, log guard and side protection plates
removed. Lift out the two cast iron bottom protection plates
from either side of the grate frame. The grate frame can
then be lifted out of the stove. When refitting the cast iron
bottom protection plates ensure that the lugs are upwards.
Removal of the Top Chamber Baffle
The top chamber baffle will need to be removed to gain
access to the flue for sweeping, also when fitting the
flue system and flue spigot if fitted to the stove when
delivered.
It is secured to the top of the stove by two stainless steel
bolts. It MUST be replaced after sweeping.
Failure to fit this baffle will cause reduced performance
and may eventually damage the stove.
1
2
1
2
Cast iron bottom protection
plate with the lugs upper most
