210-0000027 rev03
3. Connect the IDSL Line(s).
Plug the IDSL cable into the RJ21 connector for the chosen slot on the back of the IP DSLAM.
For each port being connected to a remote IDSL modem, verify that the IDSL link has been
established; the IDSL LK LED for that port will show steady illumination to indicate the
connection has been made. Link up time can vary from one to five minutes depending on the
quality, gauge and distance of the copper cables. Default bandwidth for the IAM144-12 is 144
kbps.
IDSL RJ21 Connector Port Pinout
OVERVIEW
IAM144-12 Management
Statistical and configuration data for the IAM144-12 are maintained in an embedded web server
that resides within the firmware of Net to Net Technologies' Multiplexer Uplink Modules
(MUMs). This firmware contains Net to Net's Network Management System (NMS) and Simple
Network Management Protocol (SNMP).
Accessing IAM144-12 data in a newly installed IP DSLAM
a. Connect your PC to the Ethernet RJ45 MGMT port located on the faceplate of the
MUM installed in your IP DSLAM.
b. Verify the connection; solid illumination of the MGMT LNK LED on the MUM
faceplate indicates the connection has been established.
c. Launch a web browser such as Microsoft Internet Explorer (v4.0 or higher) or
Netscape Navigator (v4.0 or higher).
d. Type the default IP address into the address field at the top of your browser and
press the Enter key.
!
192.168.254.252 if the MUM is in slot 13 (IPD12000) or slot 5 (IPD4000)
!
192.168.254.253 if the MUM is in slot 14 (IPD12000)
PORT
1
2
3
4
5
6
7
8
9
10 11 12
IDSL Tip
26 27 28 29 30 31 32 33 34 35 36 37
IDSL Ring 1
2
3
4
5
6
7
8
9
10 11 12
NOTE
Once the IAM144-12 has been installed, bandwidth and other configurations are software selectable via Net to Net
Technologies' Network Management System (NMS). For further information regarding Access Module management
and configuration please refer to the Management User Guide for IP and Mini DSLAMs.
