QSG | Quick Start Guide: PB-ISDN
|
www.net2edge.com
6
Warning
: The -48VDC power terminals are marked
0V
,
-48V
, and
GND
.
Net2Edge -48VDC products are designed for use with negative voltage DC
supplies, and therefore expect the positive voltage to be connected to the
0V
terminal, and the negative connected to
-48V
. Please be sure about the polarity
of this connection before connecting power to the terminals. Units which have a
po24VDC power source will be marked
+24VDC
,
0V
and
GND
respectively. Please ensure that the positive connection is made on the
+24VDC
terminal.
4.4 Installing DbManager
DbManager is required in order to monitor and manage the PacketBand ISDN Chassis.
Management can be made using the Terminal (serial) port, or using TCP/IP over a LAN
or WAN. DbManager is installed using the CD provided with product or can be
downloaded from the Net2Edge Website:
www.net2edge.com
1.
Insert the DbManager Installation Disk into the drive of the PC which will be used
for management of PacketBand ISDN.
2.
InstallShield Wizard will start up. Follow the steps to install DbManager.
3.
Serial Number – Enter the Serial Number on the case of the DbManager Disk.
N.B.:
DbManager is supplied as a 'Lite' version by default. This allows configuration
and monitoring of devices, but only allows configuration of a single device node and
a single user account. To use DbManager in 'Lite' mode, do not enter a serial
number during installation. Please see the full DbManager User Manual for more
information on configuring and using DbManager.
Warning:
If an older version of DbManager is already installed on the management
PC, it is necessary to update to the version supplied on the new DbManager CD.
This can be done by consulting the ‘Upgrade’ folder on the DbManager CD. The
‘readme.txt’ file explains how to upgrade to the new DbManager without reinstalling
the program.
