Other parameters might be necessary for your interface. You can enter
help ifconfig
at
the firmware prompt for details.
8. Although the environment variables and bootargs are retained, you should check that all required boot
environment variables and bootargs are properly set for your system type and configuration using the
printenv bootarg name
command and correct any errors using the
setenv variable-name
<value>
command.
a. Check the boot environment variables:
▪
bootarg.init.boot_clustered
▪
partner-sysid
▪
bootarg.init.flash_optimized
for AFF C190/AFF A220 (All Flash FAS)
▪
bootarg.init.san_optimized
for AFF A220 and All SAN Array
▪
bootarg.init.switchless_cluster.enable
b. If External Key Manager is enabled, check the bootarg values, listed in the
kenv
ASUP output:
▪
bootarg.storageencryption.support <value>
▪
bootarg.keymanager.support <value>
▪
kmip.init.interface <value>
▪
kmip.init.ipaddr <value>
▪
kmip.init.netmask <value>
▪
kmip.init.gateway <value>
c. If Onboard Key Manager is enabled, check the bootarg values, listed in the
kenv
ASUP output:
▪
bootarg.storageencryption.support <value>
▪
bootarg.keymanager.support <value>
▪
bootarg.onboard_keymanager <value>
d. Save the environment variables you changed with the
savenv
command
e. Confirm your changes using the
printenv
variable-name
command.
Boot the recovery image - AFF A220 and FAS2700
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
Steps
1. From the LOADER prompt, boot the recovery image from the USB flash drive:
boot_recovery
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the var file system:
104
Summary of Contents for AFF A700
